Make your own entryway bench with storage
Posted Nov 12, 2016 by Elmers
Favorite Button

    DIY Entryway Bench with Storage

    Enhance your entryway with this DIY entryway bench with storage. Elmer’s Carpenter’s Interior Wood Glue and Wood Filler will help you complete this project.
    • Hard

    Supplies Needed

    Step by Step Instructions

    1
    Get cutting: <ul> <li>Top panel = 58 1/12″ x 2 ft</li> <li>Bottom panel = 58 1/12″ x 2 ft</li> <li>2 end panels = 14 3/4″ x 2 ft</li> <li>2 inside panels = 14 3/4″ x 2ft.</li> </ul>
    2
    With a Kreg Drill, make Pocket Holes in the end and inside panels.
    3
    Put a bead of Elmers Interior Wood Glue along the edge and hold in place with a clamp to let it set a few minutes. Do this before trying to screw or nail boards together because there will be an even stronger bond between the materials.
    4
    Now you can add the top panel. Put wood glue on the ends and inside pieces and then place the top on and nail it down with your brad nailer and 2” nails. You could also use a regular hammer and nails.
    5
    Use your Elmer's Carpenter’s Wood Filler to fill in your pocket holes. After that dries, sand it.
    6
    Iron on a roll of wood veneer to finish off the raw edges of your cut wood. The veneer is ¾” wide, which will be perfect for your ¾” thick oak plywood. If there is any overhang, use a razor to shave it off.
    7
    Then give the wood a good wash and wax. Give it a good wash of chalk paint mixed with some water and brush it on. Then wipe it off quickly. Next use liming wax perpendicular to the grain of the oak and push the white wax into the rain and then allow it to settle into the grain.
    8
    Add a pop of color by painting the inside.
    9
    Add your “bun feet”. The example uses wooden bowls as "bun feet" from a thrift store. Drill a hole in the middle of the bun feet and then drill a hole in the base of your bench. Add them to the bottom with screws and wing nuts.
    10
    If you have baskets you want to use, use those or you can DIY your own baskets like the example. Glue and nail pieces of scrap wood together and line the old buffet warmers. Glue pads to the bottom of the buffet warmers so they don’t scratch the paint. Now that you're done, place your new entryway bench with storage in your mudroom, kitchen or other entryway. As seen on www.thriftdiving.com

    Comments

    You must be signed in to submit comments

    © 2017 Newell Office Brands.
    The Glue with the Orange Cap ®