Cupcake wall decor
Posted Jun 17, 2014 by Elmers
Favorite Button

    Cupcake Wall Decor

    • Easy to Moderate

    Supplies Needed

    For white cupcake:

    For yellow cupcake

    • 19 1/2" x 25 1/2" sheet of brown artist paper - Canson
    • Crafting beads, yellow - Jewelry Essentials
    • 80 mm diameter clear ball ornament - Darice
    • Holiday red spray paint - Color Tool by Design Master
    • Acrylic paint, yellow
    • Newspapers
    • Small plastic container
    • Button shank remover or craft cutter

    For each:



    1. To draw cupcake on Elmer's Foam Board, use pencil and acrylic ruler to draw 9" x 12" vertical rectangle. To taper rectangle for cupcake bottom, measure and mark in from bottom left side 1 3/4". Similarly measure in from bottom right side 1 3/4". Draw lines from top corners of rectangle down to marks at bottom. To draw rounded top of cupcake, trace around half of a large bowl positioned on top of rectangle. An adult should use Elmer's X-ACTO Knife (with new blade) and acrylic ruler on Cutting Mat to cut Foam Board into cupcake shape. (Hint: Score lightly first and then press more firmly to cut deeper with several passes of the knife. Replace blades often.)
    2. For white frosting, squeeze 1 - 1 1/2 tubes of textured paint onto top section of cupcake and spread with spatula or knife. Spread and swirl as desired. Let dry.
    3. For yellow icing, draw a scalloped line using Elmer's Yellow 3D Glitter Pen. Fill in yellow icing area using glitter pens. While still wet, sprinkle beads into paint. Let dry.
    4. For cupcake liner, trim orange paper to 9 3/4" x 25 1/2". Starting on one short end, make 1" wide accordion folds in orange paper. Use Elmer's Craft Bond Tacky Glue to attach right and left ends of liner to outside edges of cupcake. Let dry.
    5. Hold cupcake at desired angle to determine top and mark on back. For hanger loop, overlap ends of a 6" length of ribbon and glue to mark on back of cupcake. Let dry before hanging.


    1. Follow White Cupcake, Step 1 to draw and cut cupcake shape from Elmer's Foam Board.
    2. For "cherry", use button shank remover to carefully snip off hanger loop from one of the ball ornament halves. (Set aside other half for another project.) In a well-ventilated area protect work area with newspapers. Using red paint, spray inside of one of the ball ornament halves. Let dry.
    3. In plastic container, squeeze out 1 1/2 tubes of texture paint. Add yellow acrylic paint a few drops at a time, and mix until desired color. Spread mixture onto top section of cupcake and spread with spatula or knife. Spread and swirl as desired. While still wet, press beads into paint. Push red cherry into paint at top. Let dry.
    4. Follow White Cupcake, Steps 4 and 5 to make and glue brown paper liner and hanger loop on back.


    You must be signed in to submit comments

    © 2017 Newell Office Brands.
    The Glue with the Orange Cap ®